Related Photo Galleries
After some good "eyeballin'" we figured that the old pipe was going to have to be cut a little below the mounting bracket. With the remainder of the old pipe being held back in position in the car, and the new filler neck bolted in place, hold the J-bend on the outside of the quarter-panel at the same angle as the new filler neck and mark in the bend area of the J-bend where it would meet up with the old pipe. Try to make the cut through the J-bend as square with the side of the tube so that after its cut, the opening isn't oblong. It needs to fit well to the old pipe because they are going to be welded together.