10 Now for the positive cable. Since I am interrupting the cable with the cutoff switch, I need to make a short section that will go from the battery to one side of the switch. There are a few ways to cut these cables from bolt-cutters to cutoff wheels. The quickest way for me to cut the cable was to use a chisel and heavy hammer. This doesn’t leave the cleanest cut, but as long as I could get the terminal on I didn’t really care. I also realized at this point that I only had two terminals and shrink-tube sections in the kit so I had to take a trip to the store to get two more terminals (they were out of shrink tube). The Summit kit does not account for the cutoff switch, so if you are installing a switch make sure to order two more and some extra shrink tube.