The back of the backrest is covered with a metal panel, which received a fresh coat of paint and the new chrome trim. The top of the panel slips under these two little brackets that were removed during tear down. The best way to find where they go again is to lay the metal panel in place and mark it with tape. Then use an awl to locate the holes in the frame.The back of the backrest is covered with a metal panel, which received a fresh coat of pai The cushion cover comes together at the rear to hide the hardware... ...holding the backrest on. There are a few little tails that come down and hide where the tracks mount up as well. They go like this and are held on by—you guessed it—more hog rings. Now the metal pieces that cover the sides can be installed.There are a few little tails that come down and hide where the tracks mount up as well. Th The last thing is the two pads/bumpers that set the backrest angle. An awl will be the best way to locate the screw holes.The last thing is the two pads/bumpers that set the backrest angle. An awl will be the bes There you have it folks, a restored bucket seat. Hopefully, there is enough information in this story to give you the confidence to try the job at home.There you have it folks, a restored bucket seat. Hopefully, there is enough information in SOURCES Original Parts Group (OPG) 1770 Saturn Way Seal Beach CA 90740 800-243-8355 www.opgi.com « | 1 | 2 | 3 | View Full Article By Calin Head Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
