It's pretty much guaranteed that you'll never find a flat surface on your car when you really need one; like when you're looking for a place to hang that firewall-mounted throttle pedal on any number of '50s or '60s vehicles. There may be a lot of flat space on those firewalls, but all too often, it just seems like it's not in the right place.
That's one of the reasons Lokar developed its Eliminator floor-mounted throttle pedal assembly. It provides another option for vehicles with cramped or contoured firewalls. Of course, some people will like it for cosmetic reasons since it also moves the throttle cable mount under the floor, thereby cleaning up the firewall.
Whatever the reason, this slick cable is just the solution that many car builders are looking for. It's also pretty simple to install. See for yourself as we watch Alan Crouse install one at Classic Performance Products.
 Lokar's Eliminator floor-mounted...  Lokar's Eliminator floor-mounted throttle pedal looked right at home on the floor of this '56 F-100. The matching brake pedal helped complete the look. |
 The Eliminator pedal kit includes...  The Eliminator pedal kit includes the pedal and all necessary mounting equipment; we had to buy a Lokar throttle cable separately. Lokar suggests using a 36-inch throttle cable for most floor-mounted applications. |
 Finding a proper mounting...  Finding a proper mounting position is probably the most critical part of the installation. We suggest sitting in the driver's seat and finding a spot that will be comfortable for long-term driving. You'll also want to check under the floor to make sure there aren't any obstructions. Once you've found the spot, lay the pedal flat on the floor and mark its position. |
 Using the cable bracket as...  Using the cable bracket as a template (locating it 3/4-inch up from the bottom of the pedal), Alan marked the floor where it needed to be drilled and cut. |
 The four mounting holes then...  The four mounting holes then need to be drilled, and the center opening cut out. |
 The aftermarket access panel...  The aftermarket access panel on this truck was fiberglass, which made the process a little easier. |
 The pedal's mounting base...  The pedal's mounting base could then be bolted on. The same fasteners also held the cable bracket in place under the floor. |
 The splined side plates slid...  The splined side plates slid onto the pivot shaft, and then the pedal was attached with four Allen screws. |
 It was then time to move underneath...  It was then time to move underneath and into the engine compartment. The Lokar throttle cable was attached to the bracket as shown here. |
 Then it could be trimmed to...  Then it could be trimmed to a proper length and hooked up to the carburetor or fuel injection in standard fashion. Follow the instructions for adjustments and fine-tuning, and you'll have a pedal and throttle cable assembly that works great and looks sharp. |