The Southern Air vacuum solenoids were fitted and attached to the evaporator bracket. Then the vacuum lines were connected to the solenoids. The bracket was attached to the evaporator and slid into place. The evaporator should be mounted as far right as possible and horizontally to the dash. The bracket actually allows the evaporator to be mounted covering where the A/C lines will be routed because the bracket mounts the evaporator with a gap between the firewall and unit in order to run the lines behind it. Once in place, mark where holes need to be drilled and remove and drill.The bracket was attached to the evaporator and slid into place. The evaporator should be m The defroster is mounted before the evaporator is put back in. The vacuum lines are attached in the appropriate place on the evaporator. Then the proper ducting is securely attached to the evaporator, and the evaporator is mounted.Then the proper ducting is securely attached to the evaporator, and the evaporator is moun Below the radio the center vent is mounted. In the bottom corners of the dash the side vents are installed. Once the vents are in place the ducting is attached to the vents.In the bottom corners of the dash the side vents are installed. Once the vents are in plac A new Southern Air control panel replaces the stock switch plate. We moved back under the hood and mounted the electric water valve to the passenger side inner fender. It's extremely important to be sure to mount hardware properly by following the arrow for direction of flow.We moved back under the hood and mounted the electric water valve to the passenger side in Next the A/C and heater hoses were cut to the correct lengths. All of the lines were test fitted to their correct locations to be sure that everything was all squared up prior to having the hose ends crimped in place.All of the lines were test fitted to their correct locations to be sure that everything wa If everything matches up, it's to the crimper with the hose fittings and hose. Lastly, wire the unit according to the diagram on the instructions. Since different cars may have different wiring schematics, it is important that you study this procedure and make sure you understand where everything connects. Southern Air has done a good job of making their kit installer friendly, so be sure to take their lead and do what they tell you.Lastly, wire the unit according to the diagram on the instructions. Since different cars m The only thing left to do is get the system charged and then be prepared to turn the key on and freeze!The only thing left to do is get the system charged and then be prepared to turn the key o SOURCES Southern Rods And Parts, Inc. 2125 Airport Rd. Greer SC 29651 Sweet Components 9403 W. Marshall Ave. Glendale AZ 85305 « | 1 | 2 | View Full Article By Dakota Wentz Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
