Super Chevy
Click here to find out more!

1970 Nova Drivetrain - Change Of Pace

We Swap Out 5.38 Gears For A Set Of 5.13s To Maximize This Torque-Monster 402 Cubic Inch Big-Block.

By Mike Ficacci, Photography by Mike Ficacci

Small gear changes contribute in a big way when it comes to the maximization of a race car's quarter-mile capabilities, and the proper choice determines the quickest elapsed times. The test mule for our gear change swap is an NHRA Stock Eliminator '70 Nova powered by a steel-headed 402ci big-block. Last year, the car made the switch from a 350 ci small-block pumping out approximately 400 hp that could get down the 1,320 in approximately 10.8 seconds to the big block, which should be good enough for 9-second passes at its lightest weight.

Once owner Robert Twynam worked out all the bugs, he got the car down the track in B/Stock trim with some 10.20-second passes, good enough to place him near the top of the qualifying sheet. The problem that had become more and more evident was the over-revving of the big block with stamped steel rocker arms to 8,000-plus rpm, which led to audible valve float for the last hundred feet.

To make it in Stock Eliminator, the cars must be wrung out to the absolute max and this means pushing the factory parts to the limit and (sometimes) beyond. Rules stipulate the use of stamped steel rocker arms, a GM 12-bolt rear end, and a four-speed transmission (most competitors use either a Jerico or G-Force manual trans).

Making a rear gear change affects performance for the entire length of the quarter-mile and it doesn't matter if you are talking about a full-bore racer or a Saturday night cruiser. The trick to being successful is melding the first 60 feet with the 330 feet, followed by the eighth mile, and ultimately, the quarter.

Using 30-inch diameter radial drag slicks and trapping 126 mph, a change from 5.38 gears to 5.13s should drop trap rpm approximately 250, eliminating the valve float, and allowing the engine to work at maximum capacity.

We contacted Mark Williams Enterprises, which spec'ed out a 5.13 ring and pinion. It is lightened and polished for the strength and speed. Removing the spinning weight of the drivetrain is especially effective as you are not only lightening the automobile, but you are adding horsepower at the rear tires via a lower coefficient of drag from the flywheel to the wheels. With the 5.13s installed, Bob saw a three full mph improvement in trap speed (to 130.97), eliminated valve float and dropped 0.08 from his best e.t.

By Mike Ficacci
Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
Super Chevy