The paddle installs between the steering wheel and the hub. No wiring is required during this install. There are small batteries in the paddle that last for three years, and this is what powers the RF transmitter.The paddle installs between the steering wheel and the hub. No wiring is required during t With the steering wheel back on, this is how clean the set up should look. Now that the computer is programmed, and the actuator arm knows where each position on the transmission is, the arm and the linkage can now be tightened.Now that the computer is programmed, and the actuator arm knows where each position on the The key pad and RF receiver should be installed next, and powered up. The keypad is where most of the Smart Shift computer programming will take place. Included in the install sheet is a standard set of directions and templates that will apply to 90 percent of all possible setups.The key pad and RF receiver should be installed next, and powered up. The keypad is where There are a series of dip switches that correspond with the buttons on the keypad. This is where having a buddy helps. Have a pal under the vehicle, place the transmission in park, then on the keypad program the park button and set the dip switch accordingly. Then move down the list to drive, neutral, reverse, and so on. The installation instructions have a full page dedicated to programming the computer.There are a series of dip switches that correspond with the buttons on the keypad. This is Lastly, install of the keypad. The keypad can be installed anywhere within reach of the driver. The A-pillar, dash, console, and even the ashtray are all options.Lastly, install of the keypad. The keypad can be installed anywhere within reach of the dr In this install, the keypad was installed right into the dash of the Chevelle. And this faceplate sandwiches the keypad, all together. Lights on or off, here's what you will see once the entire system is installed. The only visible items should be the keypad and paddle shifter.Lights on or off, here's what you will see once the entire system is installed. The only v The right paddle is for upshifting, the left for downshifting. It is now time to officially go out there and flog the transmission. Have fun.The right paddle is for upshifting, the left for downshifting. It is now time to officiall SOURCES Retrotek Speed Corona CA 9-51/-737-2006 retrotekspeed.com « | 1 | 2 | View Full Article Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
