Super Chevy
Click here to find out more!

The 496 Street Bruiser - The Hunter's First Kill

This Street Killer Prowls With 700 Horses

By Mike Petralia

In this business there are occasionally projects that'll really blow you away. Last month we introduced you to The Hunter, a new engine that Hye Tech Performance assembled using a whole lot of off-the-shelf parts from Jeg's mail order. It's a 496-cid stroker Rat built for one simple purpose: to take no prisoners on the boulevard. We also told you that this was no ordinary pump-gas big-block either. Unlike so many sleeper build-ups of the past, its design was made to get attention as it rolled down the street; which it would have little trouble doing judging from the way it performed on the dyno.


Pump-Gas Power
Even though this engine emits an exhaust tone that's reminiscent of the high compression big-blocks built long ago, its pump-gas friendly 10.25:1 compression (mistakenly reported as 11:1 in last month's story) means that this beast can be filled up anywhere and for very little cash. That leaves plenty of money behind for new back rubber because this thing makes enough torque to fry any set of meats. How do 700 peak horsepower and over 640 ft-lb of torque, all below 6,500 rpm grab you? Like a giant python, this motor will squeeze every last bit of performance out of your car and anyone else you pull up against. In a 3,200-pound car with around a 3,500-rpm stall converter and some sticky tires, this engine would easily dip into the 9s and you could still drive it home.


Motor Maintenance
Although this is a pump-gas street bruiser, its race-inspired components will still require periodic maintenance to live a long healthy life. With a solid roller cam as big as this one is, you'd want to check valve lash about once a month if it's driven regularly. Also, keep an eye on the spark plugs, looking out for any signs of detonation (black spotting on the porcelain) because some gas stations have been known to put low-octane gas in their high-octane tanks and scam a few bucks. It'd be wise to carry a can of octane booster in the trunk, or better yet, add one every time you fill up, just to be safe. It's cheap insurance against a massive failure. Also, the Weiand (pronounced "Why-And") Team G intake manifold is very tall at over 7 3/8-inches. It might not clear any stock musclecar hoods or most factory cowl-induction hoods either. So, if you're planning to build an engine like this one, be prepared to buy a tall, fiberglass cowl-induction hood because the further you can keep the hood above the carb, the better you'll be able to breathe.


The Hunter's First Strike
Note: Last month we incorrectly listed The Hunter's compression at 11:1. Then engine builder Hye Tech Performance told us it actually turned out to be a more pump-gas friendly 10.25:1. Even though our original plan was for around 11:1, we felt that with aluminum heads and a large camshaft, 11:1 would work. However, in keeping with our plan to use off-the-shelf parts, the only SRP Pistons available, in conjunction with the 119cc chamber size, gave us either 10.25:1 or 13:1.

By Mike Petralia
Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
Super Chevy