Engine dynos make very good polygraphs. So many times the latest engine-building stud will brag to his friends or foes about the mighty power beneath his hood. Without any true dyno figures to back them up, who's going to dispute his claims?
Our latest dyno test session features a little stroker small-block that we've been following Sod Bogosian of Hye Tech Performance put together. Bogosian's customer wanted a unique small-block with a great torque curve, and he wasn't at all concerned with peak power numbers. He planned to drive this beast all over the place and liked the idea of having torque to spare at any rpm. So Bogosian designed and built a 391-cid Mouse that, in the end, made more than 400 lb-ft from 3,000 to 5,900 rpm and lost only 4 lb-ft at 6,000. This little pack mule eventually had no trouble cranking out more than 450 lb-ft of torque at a relatively low 4,200 rpm. That's enough to make any car's tires squeal with delight.
The new Holley Street Avenger 770-cfm vacuum secondary carb worked well right out of the b
Stroked To Perfection, A Recap
For just a few extra machine-shop dollars Bogosian offset-ground a 3.75-inch stroke 4340 C.A.T. Power Engine Parts crank by turning the rod journals down to the small, 2-inch diameter of the old 327-cid small-block. This added an extra 41 ci to the combination, making the little 350 think it's a big-block. Then Bogosian hung a set of full-floating 10.25:1 JE forged pistons on 5.7-inch 4340 H-beam C.A.T. rods and produced a stroker bottom end strong enough to haul the Queen Mary from Long Beach to Long Island without a trailer.
The top end of Bogsian's big Mouse was designed to optimize fuel efficiency and power, while still being a smooth-running street engine with great throttle response. For his top end he choose to go the dyno-matched route and selected Holley's new Street Avenger package, which included aluminum heads, an intake manifold, a cam, a carb, and all the needed accessories to go with. That way he knew he wouldn't have to waste days on the dyno figuring out which combination would work best.
While not huge by anyone's standards, we learned that the Street Avenger heads included in the Holley package did flow a respectable number and were designed mainly to make power in real street rpm ranges. That meant that a 6,500-rpm power peak was not in our future, and the 223 cfm these heads flowed at 0.500-inch lift on the intake side meant that a huge cam would not be needed to optimize the package.
Jet changes are usually worth some power when fine-tuning on the dyno, and Vrbancic came u
Bogosian chose a Lunati hydraulic camshaft with slightly more duration than the recommended Street Avenger cam because he felt that the 41-extra ci this engine displaced would need a bit more breathing room. He also asked for the cam to be ground with a 112-degree lobe-separation angle to better accept the shot of nitrous that was in this engine's future. He combined the big cam with Lunati's 1.6:1 roller rockers and a double-row timing chain to be sure the valvetrain would be up to the long-term use it would see.
With the top end finished off and a set of March Performance serpentine pulleys bolted on the damper and the Weiand water pump, Bogosian hauled the motor to Vrbancic Brother's Engine and Dyno shop for a full-day's dyno bashing. Brothers George and Bob had no trouble tuning every last ounce of useable power from this street combination.