How many of you watch TV? Probably just about every one of you. Now answer this: Who is watching all these makeover shows? To keep adding more to the lineup, you'd think the demand has to be through the roof, right? There are more makeover shows on TV than there are movies these days, it's insane! What's even more insane is seeing the before and after pictures of some of those guinea pigs.
Makeovers are no stranger to the Super Chevy crowd. After all, car makeovers are pretty much what most of us do on a regular basis, whether it's interior, exterior, engines, or air fresheners. We are constantly adding or taking away from our rides. When it comes to engines, one quick and easy way to have your Chevy powerplant stand out is to add a billet pulley system. It's a quick, easy, and a relatively inexpensive way to make your motor pop when you sling open the hood.
 |  Is it really worth showing...  Is it really worth showing some disassembly shots? It's pretty obvious there's going to be some disassembling to make way for the new Concept One components. For our first mission, the crank pulley was removed and the new polished Concept One 5-inch crank pulley was installed. |  When installing the new water...  When installing the new water pump setup, we made sure to use Teflon on our bolts. Always use the proper gear when required. |
When shopping around for a system, one company you're bound to run into is Concept One Pulley Systems. The Georgia-based manufacturer has a full lineup of pulley systems for big- and small-block applications, not to mention, the common cure for whatever accessories you want to throw into the mix. If ya don't believe us, take a look at what Concept One has to offer. For our task at hand, we have a small-block decked out with A/C, power steering, a Roots-style blower, and of course, the bare necessities that a motor needs. In the end, Concept One had the application for us.
 The kit came with this new,...  The kit came with this new, polished water pump. All we had to do was bolt up the 4.25-inch polished water pump pulley and install it. |  |  Here it's clear to see that...  Here it's clear to see that the CNC-machined parts are top-notch. Before installing the Concept One alternator bracket and arm, some mild assembly is required. The arm needs to be fastened to the brackets. |
Since our small-block rests in a Second-Gen Camaro, we had some room to play with-which is exactly what we did. We wanted to fill up as much room as possible so we could get that extra slap in the face when the hood was opened. We went with a Concept One wide kit. On a side note, Concept One does offer other kits for all sorts of applications. The wide kit is a two-belt one designed to fit cars with plenty of room on each side of the engine. The cool thing about it is that both the A/C compressor and alternator sit outside of the valve covers while keeping the accessories hung low enough for adequate hood clearance. The kit is designed for small- and big-block Chevrolet engines, and it works with aluminum, Vortec, and late-model cast-iron heads with accessory bolt holes. All A/C kits are designed to fit the Sanden SD 508 compressors with serpentine pulleys, and the alternator kits fit most standard alternators with a 6.575-inch bolt pattern. When it comes to compressors and alternators, some kits have an option to buy. Some come standard, but in the end Concept One keeps both in stock for your ordering pleasure. Each kit features Concept One's overdrive technology, which increases water flow and electrical system charging at idle and slow speeds. The kits are CNC-milled from 6061 billet aluminum, and are available in raw or polished finishes.