Tire Pressure Monitoring System - Techno Tires

Each sensor is dedicated to a specific wheel. This sensor shows an "LF" on the bottom line, indicating that it should be installed on the left front wheel. Because we are using different width wheels in the front and back and our tires are directional, it was easy to remember which sensors go on which wheels. On other applications, it's a good idea to immediately apply the included stickers that tell where the wheel should be installed.

The band is installed much like a hose clamp.

The sensor should be placed 180 degrees from the weight.

Special precaution should be taken to ensure the SmarTire sensor is not damaged when re-installing the tires. The backside of the tire bead should be below the sensor.

Install the band so that the notch in the counterweight is lined up with the valve stem.

Remounting low-profile tires on billet wheels requires special care. One of the things Wheel Warehouse does is to start with ample lubrication.

Then the tire was installed.

Wheel Warehouse utilizes a special computer-controlled balancer to ensure the balance is perfect.

This is especially vital when mounting accessories inside the wheels.

There are two methods to mount the SmarTire receiver. One is to use a visor clip. The other is to use a special mounting bracket and Velcro to attach the receiver to you dash. This is the method we choose

Finish off by plugging the SmarTire receiver into the 12-volt outlet and you are ready to test everything out.