The DSE provided dimension for the center point of the coilover bracket is 14 3/4 inches. With the centerline determined for each bracket, Matt does some simple math and locates both brackets.With the centerline determined for each bracket, Matt does some simple math and locates bo Bracket is tack-welded to the housing. The DSE provided measurement from the center of the housing to the centerline of the link bracket is 19 5/8 inches.The DSE provided measurement from the center of the housing to the centerline of the link Angle locater is placed on links mounting bracket, and set at a 90-degree angle. The bottom of the coilover bracket is set at zero degrees. Keep in mind that both upper- and lower-end links feature adjustability for ultimate suspension tuning.The bottom of the coilover bracket is set at zero degrees. Keep in mind that both upper- a The coilover bracket is welded to the housing. The DSE lower link bolts to the DSE mounting bracket that is bolted in at the OEM leaf spring front mounting perch.The DSE lower link bolts to the DSE mounting bracket that is bolted in at the OEM leaf spr In Matt Duque's words, this rear suspension is "definitely the strongest setup I've seen-a stout piece that will definitely deliver the torque to the rear wheels."In Matt Duque's words, this rear suspension is "definitely the strongest setup I've seen-a The rear is placed on a floor jack, and lifted in place, with special attention given to lining up the upper and lower four link bars.The rear is placed on a floor jack, and lifted in place, with special attention given to l Panhard bar and Koni coilovers are bolted in at this time SOURCES Detroit Speed and Engineering 7-04/-662-3272 www.detroitspeed.com Route 66 Motorsports 8-15/-462-0090 www.rt66motorsports.com Strange Engineering Morton Grove IL 8-47/-663-1701 Strangeengineering.net « | 1 | 2 | 3 | View Full Article By Arvid Svendsen Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
