With the new ball joints installed (a separate job in itself) we add the new spindles and slide the new springs in (all part of the TVS package).With the new ball joints installed (a separate job in itself) we add the new spindles and Raise the lower A-arm with a jack and secure the bottom of the spindle. Install the Bilsteins now. After tightening the bolts for the disc backing plate, bend the tang over the bolt head to keep it from backing off.After tightening the bolts for the disc backing plate, bend the tang over the bolt head to Then we thoroughly clean the Master Power Brake discs... ...install the bearings, seal with generous amounts of grease... ...and slide the rotor onto the spindle. Install the caliper assembly and the steering linkage, tighten up, and we're ready to finish with the sway bar.Install the caliper assembly and the steering linkage, tighten up, and we're ready to fini In case you're second guessing us, we didn't forget to install the brake lines, we're just saving that for another installment. We'll go with entirely new parts on that job also.In case you're second guessing us, we didn't forget to install the brake lines, we're just Mark the spots using the sway bar as a template, then drill holes for the mounting brackets.Mark the spots using the sway bar as a template, then drill holes for the mounting bracket Grease and install the end links, grease up the bushings in the brackets... ...tighten up and we're ready to roll. All new, and all good! SOURCES Currie Enterprises 7-14/-528-6957 www.currieenterprises.com Master Power Brakes 254-1 Rolling Hills Rd. Mooresville NC 28117 704-664-8866 www.mpbrakes.com Hotchkis Performance 12035 Burke St., Ste. 13 Santa Fe Springs CA 90670 877-466-7655 www.hotchkis.net « | 1 | 2 | 3 | View Full Article Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
