Light 'Em Up - LED Taillights for First-Gen Camaros
|
There are four templates, which must be cut out of the supplied template sheet. These templates are for the LED circuit board mounting holes that must be drilled into the top and bottom sides of both the left-hand (driver side) and right hand (passenger side) taillight housings. Tape these templates to the housings as shown in this photograph. Each template is specifically marked as to its position (top or bottom) of the housing. The physical molding configuration of the housing will match the template to insure correct indexing to the housing. This procedure is the same for either the Standard or Rally Sport housing. View Related Article
|
|