When it comes to vintage specialty vehicles, there never seems to be an end to ideas and designs. From a '30s street rod to the rebuild of a '70s muscle car, an enthusiast will go out of their way to have something like no other. The same goes for Dick Coup of Ft. Worth, Texas. Dick has been a fan of road track racing all his life and has participated on the ISCA show circuit with his '64 Corvette. Dick, a master of fiberglass, decided to build another Corvette which would be a modified replica of the '63 Grand Sport (only five were produced and all have been restored).
As with any complete build or restoration, several things need to be accomplished. Wiring is one of those necessary items for proper vehicle operation and dependability. Dick contacted the folks at Painless Performance (also in Ft. Worth) for advice on his wiring needs. John Roberts, one of the guys seen in the Painless booth at many shows, went to look at the Corvette and suggested the use of one of Painless' new Micro Remote mount harnesses. This harness will allow the fuse block to be mounted anywhere in the car. This filled the bill because Dick wanted the fuse block in the center console along with all the other special electrical switches.
Great pains were taken to make the car a one of a kind-even down to the small lights that illuminate the numbers on the doors. The micro harness has enough circuits for all the options-even for the air conditioning Dick is adding. Being the car show guy he is, Dick even made special tubes and troughs to hold and conceal the wiring.
Wiring is usually something that is done by someone other than the enthusiast car owner because of how intimidating it can be. Dick is no different. "I'll do almost anything with fiberglass but the wiring, I leave that to someone else" In the following segments, John will show how easy the Painless harness was to install.