Subscribe to the Free

2001 Camaro Z28 Project Car - Infusion

Project Black Betty Gets A Bit More Power And A Much Better Clutch.

View Full Gallery

When we picked up our super-sano 2001 Camaro Z28 project car for 7,500 bucks we were pretty stoked. The downside to the affordable price was that the car had over 110,000 miles on the clock, and even though the owner had babied the car, there were a few small oil leaks and the clutch was getting sort of "iffy." Back when the Z was new, it was rated at 310 hp and 340 lb-ft of torque at the crank. Many people, including us, have found those numbers to be on the conservative side. When we strapped our ride to the dyno at K&N Filters, we were pretty happy with the 322 hp and 341 pounds of twist reaching our rear wheels. After doing a K&N filter and adding in some SCT programming, those numbers were ratcheted up to 334 hp and 353 lb-ft. The problem was, we wanted a little more.

Camp_1102_03_o 2001_camaro_z28_project_car Black_betty 2/23

Now, if this was a classic Camaro we could easily launch the power numbers into low Earth orbit, but we're talking a newer ride in one of the toughest emission states around: California. Here in sunny SoCal, all cars newer than a '75 have to run through a sniff test every two years. They also have to pass a visual inspection, and added parts such as headers and air intakes need to have a sticker showing they have been certified by the California Air Resources Board, affectionately referred to as CARB (and un-affectionately known by several other unprintable names). Toss on a set of long tubes and you'll fail the visual. Stick in too lumpy of a cam and you'll set off alarms on the sniff test. Needless to say, have discrepancies in either aspect of the test, and you'll incur the wrath of California's bloated bureaucracy.

Our solution was to see what we could do while working within the rules. We would up the cam duration just a touch and increase the lift to better suit a pair of ported GM heads. By increasing the cam size and improving the head flow, our LS1 would make a bit more power. On the exhaust side, our only real option was installing some shorty JBA headers. These pipes have been given the CARB blessing and weigh much less than the cast-iron exhaust manifolds. They should also be worth a few ponies and they look a whole lot better.

Getting the engine out of the Camaro would also let us replace some of the seals and gaskets that had started to seep. We additionally felt this would be the perfect time to swap our tired GM clutch for a high-performance unit from Advanced Clutch Technologies (ACT). So, with parts in hand, we headed over to Don Lee Auto to see if we could infuse our Z28 project car with a bit more performance.


Automotive Racing Products
Ventura , CA 93003
Don Lee Auto
Cucamonga, 91730
Royal Purple
Porter, TX 77365
Patriot Performance
Rainbow, AL 35906
Advanced Clutch Technology
Lancaster, CA 93535
Hurst Shifters
Chatsworth, CA 91311



Connect With Us

Get Latest News and Articles. Newsletter Sign Up

sponsored links

subscribe to the magazine

get digital get print