327 Small Block Chevy - The Misfit

327 Part Duex

Sean Haggai Oct 1, 2008 0 Comment(s)
0810chp_01_z 327_small_block_chevy Front_view 1/17

If you recall our three-for-all engine build and test, "Three-Way Mousefest" (Aug. '08), we built and tested three radically different mills (327ci, 355ci, and 383ci) and showcased what could be done with today's modern off-the-shelf parts. Our Misfit 327 churned out an impressive 391 hp on pump juice for around $4,000. Now it's time to add some zip to the little mule. To recap our combo, we utilized a cast crank and rods, flat-top hypereutectic pistons, a hydraulic flat tappet cam, a Dart Iron Eagle top-end kit, and a 2-inch Wilson manifold spacer-nothing crazy by any means.

For this edition, we talked to Weiand, a division of Holley, which offers this 142-series blower. It's the smallest blower they offer and produces up to 5.5 psi of boost. For our mill, it's a perfect combination. To put it simply, the blower kit comes complete with everything you need and installing it is as simple as a manifold swap. To make sure our breathing stays as efficient as possible, we also swapped out the old lifters in favor of a set from Comp Cams, along with a nitrided blower specific grind. When we discovered the 1.7:1 ratio rockers were causing the little 327 to be down on power, we reevaluated the situation. Basically, the larger 1.7 ratio was causing the cam to actually lose lift in the dyno pull. However, on hand was a set of smaller Comp 1.65:1 ratio rockers, which we swapped in (although Scorpion does offer rockers ranging from 1.3 to 1.7:1). The new ratio got our lift back and cooperated well with our blower grind 'stick. How much did it add? Sixty horsepower and 52 lb-ft-impressive indeed, but read on to find out the juicy details.

Quick Notes
The job

A cam and lifter swap with a blower on top

Bottom line
Big power for little cash

Price (Approx)
$1,750

MORE PHOTOS

VIEW FULL GALLERY

COMMENTS

subscribe to the magazine

get digital get print
TO TOP