1957 Chevy Nomad - Madvette

Barry Kluczyk Apr 1, 2001 0 Comment(s)
Sucp_0104_01_z 1957_nomad Side_view 2/2
Sucp_0104_01_s 1957_nomad Side_view 3/2

Joel Kowalski has a history of chopping up Chevys-particularly Corvettes. There's a bar in his hometown of Muskegon, Michigan, that has a piece of his wall-hanging art-a sliced-in-half Corvette body. Back in 1972, he even built a mid-engined '70 Vette. But the last few years of this machine shop owner's spare time have been spent on his "Madvette" a genuine '57 Nomad body mated to a '95 Corvette chassis and interior. It was an idea he concocted some years ago, but came together when he found an appropriate donor Nomad.

Of course, finding a viable Nomad to cut up was a challenge. Only 6,500 were built in '57, making it the rarest of the Tri-five Nomads. Through a local buyers guide, he located the car behind a Detroit brake shop-more than 200 miles from home. And before you purists send us nasty letters about Kowalski's desecration of such a rare Bow Tie, consider its as-found condition. "Calling it a complete wreck is an understatement," Kowalski says. "There literally was a tree growing up through the hood, and the dashboard was gone." Rust had taken hold of the Nomad, too. "The quarters were all rotted," he says. "Every one needed to be replaced."

But the all-important Bel Air trim, including the chrome and stainless steel pieces, was intact and in good shape

After dragging the Nomad back to Muskegon, Kowalski turned his attention to locating another donor vehicle, this time a Corvette chassis to cannibalize. At the Vette Shoppe in Fort Collins, Colorado, he found one: A '95 chassis with an LT1-and-automatic transmission combination.

With both cars in his garage, and a tape measure in hand, this mad man took some measurements and quickly broke out his tin snips. The Corvette's chassis wasn't as long as the Nomad's wheelbase, so Kowalski cut the Vette chassis just in front of the rear wheels and added 22 inches of boxed steel to the frame. A new, larger fuel tank was fabricated, too. It's flatter than the stock Vette's, which was necessary to clear the Nomad's rear floor. Kowalski made sure the new tank's filler neck fit behind the stock tailfin trim piece, too.

Lengthening the Corvette's chassis wasn't the only challenge. The Corvette's firewall was sliced open from left to right and a 3-inch-tall section was added to better fit the Nomad's cowl. This modification also raised the Corvette's dashboard 3 inches. But the sheetmetal cutting was far from over.

You'll notice from the photos that the Nomad's roof is chopped, and that the front end tilts. Kowalski performed those tricks, too. Look closely and you'll see that the 2-inch top chop is raked slightly. It gives the car some extra attitude, but it gave the builder fits when fitting the glass.

"I broke two windshields and 13 curved glass windows for the rear," Kowalski says. "I finally got fed up and let some pros handle it."


Connect With Us

Get Latest News and Articles. Newsletter Sign Up

subscribe to the magazine

get digital get print